RAVENOL AHC Fluid
- 1 L | 1324101-001
- Fully synthetic
- Special hydraulic fluids
- Nissan KLG01-00501EU, KLG01-00502
- Toyota AHC-Fluid
RAVENOL AHC Active Height Control Fluid is a fully synthetic hydraulic fluid based on PAO (Poly-alpha-olefin) and Ester.
RAVENOL AHC Active Height Control Fluid is used as suspension fluid for active height control systems (AHC) for vehicles from Toyota and Lexus as well as for HBMC systems (Hydraulic Body Motion Control) from Nissan and Infiniti.
RAVENOL AHC Active Height Control Fluid is used in vehicles from Toyota, Lexus, Nissan and Infiniti that are equipped with an active height control system. This system was designed not only to change the position of the suspension system, but also to give the car a special softness.
RAVENOL AHC Active Height Control Fluid is especially suitable for the active control system of vehicles from Toyota, Lexus, Nissan and Infiniti. The AHC system holds approx. 4.5 liters. The change with RAVENOL AHC Active Height Control Fluid should take place approx. every 90,000 km. Oil change intervals according to the manufacturer's instructions.
RAVENOL AHC Active Height Control Fluid is suitable for use in the following vehicles: Toyota Land Cruiser 100 and 200, Lexus LX470 and LX570, Nissan Patrol, Infiniti QX.
Warning: Never use brake fluid instead of RAVENOL AHC Active Height Control Fluid. This leads to the erosion of polymer seals in the system.
RAVENOL AHC Active Height Control Fluid offers:
- a high performance level
- a very good viscosity temperature behaviour
- a high aging resistant
- an excellent corrosion protection
- a solid corrosion protection
- neutral towards sealing materials
|Density at 20°C||kg/m³||859||EN ISO 12185|
|kinematic viscosity at 100°C||mm²/s||2,85||DIN 51562-1|
|Viscosity at 40°C||mm²/s||10,28||DIN 51562-1|
|Viscosity index VI||132||DIN ISO 2909|
|Pourpoint||°C||-60||DIN ISO 3016|
|Flash point||°C||195||DIN ISO 2592|
|TBN||mg KOH/g||2,38||ASTM D2896|
|VKA Vier Kugel Test (Verschleiß)||mm||0,45||DIN EN ISO 20623|
|KRL KV 40 °C||mm²/s||10,28||DIN EN ISO 20844|
|KRL KV 100 °C||mm²/s||2,85||DIN EN ISO 20844|
|Foaming behavior SEQ I||ml||0/0||ASTM D892|
|Foaming Behavior SEQ II||ml||0/0||ASTM D892|
|Foaming behavior SEQ III||ml||0/0||ASTM D892|
|Cu-Korrosion bei 150°C||1a||ASTM D130|